Done Allow signed numbers to be read with @BPEEK

[dcantor]

It would be nice if one could read a signed number using @BPEEK.

Let's say that a @BPEEK call
SET X=%@BPEEK[%BH,%offset,1]
If the byte was intended to contain the number -2, in this case X would be 254.

I envision an additional flag indicating a signed or unsigned read.

 

[MPB]

I just updated my v33 to v34 and ran into an odd issue with one of my batch files, and it seems like it's related to a change in @BPEEK. I could summarize here but I should open a new thread... :)