Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

Everything.exe - 64-bit?

Jul
304
0
When I install TCMD (v18), it installs Everything.exe. But the version it installs is 32-bit. Is this because there is no 64-bit version?

I ask because at times Everything seems to hang just a bit.

Chuck Billow
 
On my
Code:
c:\program files\jpsoft\tcmd18_x64>ver

TCC  18.00.32 x64   Windows 7 [Version 6.1.7601]

...the 64-bit version was installed, and is used...
Code:
c:\program files\jpsoft\tcmd18_x64>file everything.exe
everything.exe: PE32+ executable (GUI) x86-64, for MS Windows

The 32-bit version;
Code:
x:\program files\jpsoft\tcmd18>ver

TCC  18.00.32   Windows 7 [Version 6.1.7601]

x:\program files\jpsoft\tcmd18>file everything.exe
everything.exe: PE32 executable (GUI) Intel 80386, for MS Windows
Joe
 
@Joe: When I run

[C:\Program Files\JPSoft\TCMD18_x64]file everything.exe
TCC: Unknown command "file"

@Rex: The installer I used was/is tcmdx64_v18_0_32. But the window for the install shows Take Command x64. But, then when I downloaded and ran the Everything update, it was/is Everything-1.4.1.877.x86.

Is there a x64 Everything update? I'll go look...
 
Rex: I found Everything-1.4.1.895.x64-Setup online, but it looks, when install is started, that it is going to install a separate version in C:\Program Files\Everything as opposed to "C:\Program Files\JPSoft\TCMD18_x64" where the TCMD install put the x86 version. so...?
 
I figured that. So then should I re-install TCMD, and if so, how do I end up with the 64-bit Everything? There was an update to Everything (from JPSoft) that brought the version of Everything to 1.4.1.877 in 2017. I just copied over the Everything files to the TCMD install. It was/is no doubt that I copied an x86 version . Is there an x64 version that I can access?
 

Similar threads

Back
Top