Win10 x64 Home
TC 20.11.46
So far this morning, Take Command has stopped working on two different occasions, putting up the "Stopped working" message, then a dialog announcing it is restarting.
TC was sitting minimized with two tabs, each tab running Powershell.
There is no tab running tcc.
Any ideas on how to figure out what is causing TC to stop?
Thanks --
TC 20.11.46
So far this morning, Take Command has stopped working on two different occasions, putting up the "Stopped working" message, then a dialog announcing it is restarting.
TC was sitting minimized with two tabs, each tab running Powershell.
There is no tab running tcc.
Any ideas on how to figure out what is causing TC to stop?
Thanks --