Momentary huge white window after closing maximized TCMD.

[vefatica]

Maximize TCMD; close it; start it again. It's maximized (this is working good now). Close it again. The window dissappears almost immediately but about 2 seconds later a huge nearly all white window flashes on my desktop (for just a split second). It's the same with/without ConPty.

 

[vefatica]

This problem persists in build 34.

 

[rconn]

This problem persists in build 34.

Not reproducible here.

 

[vefatica]

You can see it happen in the attached video.

 

[rconn]

I believe it's happening on your system. But it's not happening on the several ones I tried, and unless others say they're seeing the same thing there's not much I can do about it.

 

[Alpengreis]

JFI: It seems I have that effect too here (at least in build 33). Here it's extreme short ... however, I can see the big white screen ...

PS: I think I made a mistake. The problem doesn't occur after the TCMD window has already been closed. Instead, it always occurs after maximizing and following closing the window, including the first time.

 

[Rodolfo]

I too see something flashing, both when I start TakeCommand 36.34 and when I close it.
This happens in my pc with only one tab with TCC.
It is too fast, just a flash, so I am not sure if it is a white page (it seems so) or something else.
Thank You and regards
Rodolfo Giovanninetti

 

[vefatica]

In another thread, Rex mentioned the Desktop Window Manager (dwm.exe). You can kill it; it starts right up again. After doing that this problem was gone.