1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

xBase Scripting

Discussion in 'T&T - Miscellaneous' started by Joe Caverly, Feb 21, 2011.

  1. Joe Caverly

    Joined:
    Aug 28, 2009
    Messages:
    680
    Likes Received:
    8
    continued from http://www.jpsoft.com/forums/showthread.php?p=13850

    If FoxPro is installed, it can be accessed via Active Scripting from TCC. Refer to http://www.jpsoft.com/forums/showthread.php?t=1851.

    Since that post, I have moved onto xBScript and Harbour, which work very well from TCC. Unlike FoxPro, all I have to do is either cscript whatever.prg from TCC, or I can use Harbour to make a stand-alone .EXE, without one single change to my DOS Clipper code.

    Not sure what you mean by "signature". I do all of my posting and replying via the forum, not from email.

    Joe
     
  2. Steve Fabian

    Joined:
    May 20, 2008
    Messages:
    3,520
    Likes Received:
    4
    ---- Original Message ----
    From: Joe Caverly
    | Not sure what you mean by "signature". I do all of my posting and
    | replying via the forum, not from email.

    When you quoted from my earlier post, you included in the quotation the signature line ("Steve") and the separator which preceded it ("-- "). I do everything not graphics oriented from the keyboard, including forum access, which I find to be a lot easier by email.
    --
    Steve
     

Share This Page