This is not exactly a "new" problem for me, but because of what I'm working on now it's become rather critical. What am I talking about? Specifically, when I scroll down in data from a "pipe" using the "list" command by pressing the "down arrow" key, lines scrolled up from the pipe to the bottom of the screen appear entirely blank. This has been happening for a very long time and I've been working around it by using the "page down" key (it works OK) and then scrolling back up with the “up arrow” key to see what I want to see. However, because of the level of detail in the data that I'm working on now, this has become an entirely non-acceptable “solution” because I keep losing my place entirely in the data (information from "section" to "section" of the data is very similar - differing in only a few characters). Is there a fix for this that doesn't involve upgrading to a new version of Take Command for a price? Because of my current financial conditions (I am retired due to my disabilities and living on a fixed income and recently had to buy another (used) car because an auto mechanic literally destroyed my car without taking any financial responsibility for it (and they even admit they did it!!!) and the amount of money the insurance company paid me (they totaled it!!!) was not enough to buy a "decent" used car in and of itself – and even though several lawyers I’ve talked to have told me that I definitely had a case they also told me that they (and any other lawyer) wouldn’t touch it because the total amount of money involved is less than $10,000.00. I’m sorry if this is entirely too much information, but I had to make my point). At any rate, is there anything I can do about this problem like downloading a “patch”? Again, it’s become a serious problem for me!!!